LS-212 Dust Test Chamber

LS-215-2 Xenon Aging Chamber
LS-211 Rain Test Chamber
1-2-7

LS-212 Dust Test Chamber

Categorie:

  • Descrizione
  • Inchiesta

LS-212 Dust Test Chamber

Uso

It simulates the destructive effect of natural wind and sand climate on the product and is suitable for testing the seal performance of the product enclosure. It is mainly used for testing the two grades of IP5X and IP6X specified in the enclosure protection standard.Carrying dust vertical circulation of air, test equipment with dust can be recycled, the whole duct made of imported advanced stainless steel plate at the bottom of the air duct connected with taper hopper interface, fan outlet directly connected to the air duct, and then in the appropriate position will studio top spread port access studio, forming vertical blowing dust “O” type closed loop system, make the air can flow smoothly, large extent makes the dust dispersed evenly.A single high power low noise centrifugal fan is used to adjust the wind speed according to the test requirements.

LS-212 Dust Test Chamber

Structural characteristics

  1. The user can independently control the conditions of F1, F2 and F3 on the panel with the powerful dust spraying device.
  2. Use vibration equipment to make the dust concentration of each spraying be the same.
  3. The precision dust concentration collector can reduce the estimation of concentration due to improper operation.
  4. Dust and dust can be Shared
  5. The sand and dust test box is applicable to test the sealing performance of the product enclosure. It is mainly used for the test of the two grades of IP5X and IP6X specified in the enclosure protection standard.

 

LS-212 Dust Test Chamber

Specifica

ModelloUNBC
Inner size（mm）800*800*8001000*1000*10001000*1000*1500
SpeciesTalcum powder
Duration time2hours or 8 ore
Temperatura di provaRT~7 ℃
Test humidity45%-75%RH
Nominal diameter of metal screen mesh50micron
Nominal spacing between lines75micron
Wind speed≥2m/s
Dust concentration2~4Kg/m3
Dust requirementsMeet with JIS6 requirement（Or national standards）
Oscillator period0-99H99M99S
Blowing dust setThe time of continuous and periodic dusting is determined arbitrarily
External materialHigh quality cold rolled steel sheet electrostatic spraying
Inner materialSUB304Precision welding of quality stainless steel plate
Thermal insulation materialUltrafine glass fiber cotton
Safety protectionOvertemperature and overlimit alarm protection, power leakage, corto circuito, lack of phase protection, undervoltage protection
EnergiaAC220/380V±10%，1PH，50/60HZ
la forza d'impatto e la rottura della risonanza dovrebbero essere principalmente considerate. È dimostrato teoricamente che la fatica dei componenti di vibrazione è proporzionale alla velocità di vibrazioneVacuum pump one, gas flowmeter, air source excuse, pressure gauge, oil and water separator

Contattaci





prodotti correlati