300mm Micrometer Adjustable Film Applicator

300mm Micrometer Adjustable Film Applicator

Use

Adjustable coating device by adjusting the two differentiators above the coating device, the scraper below can be adjusted up and down to control the gap, that is, the thickness of the final coating.The clearance of the scraper is adjusted every 10 microns, and the coating range is from 0 to 3500μm.

Basic parameters

1. Effective scraping width: 300mm

2, overall size: 316×115×60mm

3. Net weight of the instrument: 750 grams

4, precision: ±2μm

300mm Micrometer Adjustable Film Applicator

Operate

1, before the use of the instrument is generally adjusted in the “0” position, if not “0” position should be adjusted on the parallel plate of the instrument “0”, when “0”, rotate the two differentiators, so that the bottom end of the scraper and the bottom of the two sides of the plate in the same plane.At this point, the reading of the differentiator should be the same, and the “0” scale on the top of the differentiator should be aligned with the scale line on the bottom.

2. Rotate the differentiator and adjust the scraper to the required clearance, that is, the required coating thickness.Then hold both sides of the plate by hand on the sample for scraping and coating, preparation of the required coating.
3. After use, wash and dry the instrument with solvent.

Adjust the scraper so that the spring is in a relaxed state to reduce spring fatigue.Put the instrument in the packing box.